Choose 'Exit' to start minicom with chosen settings.Set Serial Device to correct value (eg /dev/ttyUSB0).Go to serial port setup and disable hardware flow control.Go to modem and dialing menu and set init string to blank.Run ' minicom -S' command and set following values:.Feb 28 10:29:56 localhost kernel: usb 3-1: configuration #1 chosen from 1 choice Feb 28 10:29:56 localhost kernel: pl2303 3-1:1.0: pl2303 converter detected Feb 28 10:29:56 localhost kernel: usb 3-1: pl2303 converter now attached to ttyUSB0 In this case name is ttyUSB0 Connect USB-to-serial converter to laptop/PC and note the name of USB deviceįeb 28 10:29:56 localhost kernel: usb 3-1: new full speed USB device number 6 using xhci_hcd Feb 28 10:29:56 localhost kernel: usb 3-1: New USB device found, idVendor=067b, idProduct=2303 Feb 28 10:29:56 localhost kernel: usb 3-1: New USB device strings: Mfr=1, Product=2, SerialNumber=0 Feb 28 10:29:56 localhost kernel: usb 3-1: Product: USB-Serial Controller Feb 28 10:29:56 localhost kernel: usb 3-1: Manufacturer: Prolific Technology Inc. ![]() Start a root terminal and run " tail -f /var/log/messages" command.To connect to a Cisco switch or Juniper switch using USB-to-serial converter and minicom use: One can use minicom to connect to switches using serial port or using USB to serial converters. Home > CentOS > CentOS 6.x > System administration tools > minicom Basic minicom configuration
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |